So you’re thinking about getting light headed bar to the back of your truck?
It looks cool on the back and add some lighting for drivers behind you.
But you wonder how complicated it was to install led light bar on your truck? You need
some ideas because you are not sure you want to go into something very complicated.

We’re here Edgeolite truck sales, led lights, we came out with a simple installation of this article to assist you in decision-making process to set the bar led lamp in the back of the truck. This article is only to give an idea of the basic installation process for the led light behind the bar, but the installation may vary from truck to truck. You must go by the manufacturers installation guide to install your led light.

Here are the basics of them to put a rear LED light bars mounted below the truck bed in the back of your truck.
Light panel is used in addition to the rear tail lights on all functions: parking lot lighting lamps, stop lamps, turn signal lights. Weekend mechanic average LED light bar wired into the towing trucks plug adapter around ½ hour-1 hour ..

Look under the truck to find a towing harness adapter is usually to the left under the rear bumper, above the rear frame rails. If your tow truck is equipped with a connector, or at least a cable attached to the frame or body to be used, as the manufacturer’s standard cable harness. Cut the wire loom to see the color of wire and then strip them to expose about one inch core copper wire for each.

Then the pair toward the light at the back of the truck bed tail gate downstairs. Using what he had ordered the factory to use to attach to the truck. Make sure the cable is led in the same area truck
utilizing cable striped earlier.

Now, using the butt plug wire pairs the same color to form, led the same color of light on the truck’s armor. (Note I want to use shrink tubing on all connections to ensure no water vapor in the connection) Then wrap each connection with electrical tape one at a time each connection is made. Remember to follow directions from the manufacturer of the lamp cord, but this information must be near here again to give you a good idea of the work involved in installing the bar, led lamp.

Then run the test and make sure all the led light to work with the rest of your vehicle lights. If all is fine. Now go head and attach the cable and new cable to take advantage of the truck frame in a neat fashion using plastic wire ties. Make sure no one will rub through a wire